Camera-based smoke and flame detection gives early fire warning in places where ceiling detectors react late or cannot reach, such as high-bay warehouses, tall racks and open areas. Cameras watch the area continuously, vision AI detects and verifies smoke or flame in the image, and the alert tells the nearest people where the event is. TIM INSPECT Fire & Smoke Early Warning works this way, as an early-warning layer alongside your certified fire detection system, not instead of it.
Point smoke detectors on the ceiling work by waiting for smoke to reach them. In a high-ceiling warehouse or production hall, that takes time: smoke has to rise, spread and build up before it triggers anything. Open areas and high racks cannot always be fully covered by detectors, and smoke can be trapped or diverted by racking and airflow on the way up.
There is also a location problem. When the alarm sounds, it is not immediately clear where the fire is. Precious minutes go into finding the source while people evacuate. Fire safety guidance, such as the UK Health and Safety Executive's material on fire and explosion risks at work, stresses detecting a fire early and acting quickly; in a large building, knowing where to act is half of acting quickly.
The TIM INSPECT workflow runs in four steps:
Picture smoke starting to rise inside a high-ceiling production hall. At that height, it would take time to reach the detectors. The hall camera shows the sign, the system frames and verifies it, the nearest workers hear where it is, and the safety officer sees the image and directs the team, all while the event is still small.
Steam and dust can look like smoke in an image, so site-specific tuning is essential. Areas with process steam or dust are taken into account during setup, and signs are verified with the image. Event records also show which steam and dust sources cause false alarms, so the tuning can be adjusted over time.
This solution does not replace a certified fire detection system. It is positioned alongside it as early warning and can connect to the existing fire panel as additional information. The limits of responsibility are set out clearly in the contract at the start of the project.
Early warning only helps if people can get out, so pair it with Emergency Exit & Route Monitoring, which flags blocked exits and routes. Both run on the TIM INSPECT platform. The full workflow is on the fire and smoke early warning page.
No. It works alongside a certified system as early warning and can pass information to the existing fire panel.
They can, which is why setup includes site-specific tuning and every sign is verified with the image.
No. The scenario works with fixed cameras; a thermal camera is added only where abnormal heating needs watching.
The nearest workers' AXION devices announce the location, and the safety officer receives the event image.
No. Areas and events are monitored, not identities, and only the event moment is stored.
If you want to see where cameras could add early warning in your buildings, request a demo and we can review your high-bay areas and existing detection together.