Small components such as snap rings, horseshoe washers and plugs are among the hardest assembly details to inspect, because they sit inside the part where a fixed camera cannot see them reliably. The practical answer is to take the camera to the inspection point: the operator photographs each point with a camera on the hand, an AI model returns OK or NOK within seconds, and the result is written to SAP with an evidence photo. TIM INSPECT Component Assembly Inspection works this way with the VEGA-X smart glove.
A snap ring that is not seated in its groove, a washer left out, a plug that was never pushed in: each is a small detail, yet any of them can turn a finished part into a field failure. The defect is rarely visible from the outside. The component sits deep in the assembly, often in a bore or behind a flange, and it looks almost the same whether it is correctly seated or not.
When such a part reaches the customer, the cost is far larger than the component itself: a complaint, a containment action, sorting at the customer's site and a search through records to find which parts are affected. Without a photo and a time stamp for each part, that search is mostly guesswork.
The solution splits the work between a device that captures and a platform that decides. VEGA-X, the smart glove, scans the barcode, takes the photo and tells the operator the result. The OK or NOK decision is made by TIM INSPECT, using Thread In Motion's own models trained on industrial images.
Take a snap ring as an example. The model looks for the hole and both edges of the ring. If the hole is found but only one edge is detected, the ring is not seated and the decision is NOK. The glove vibrates and its light turns red, the operator seats the ring, photographs the same point again, and only an OK lets the part continue.
Images on an assembly line are rarely clean. They are very close-up greyscale shots taken with glare, oil and shadows in the frame. The models are trained on industrial images of exactly this kind. For a new part, the scope is assessed using sample images from your own floor before anything is promised.
At an automotive supplier, component assembly inspection has completed more than 12.8 million inspections with zero defective parts reaching the customer, at under 4 seconds per inspection end to end, from photo to feedback. These figures come from the Thread In Motion project report for that deployment.
Quick-connect fittings raise a similar question of whether a connection is fully seated; see Quick-Connect Verification. Both run on the same TIM INSPECT platform for operational vision AI.
The inspection points sit inside the part and the background changes with every shot, so a fixed camera cannot see them reliably. A camera on the hand reaches the point up close and at the right angle.
No. VEGA-X scans, captures and reports the result. The decision is made by TIM INSPECT with Thread In Motion's own models.
The commitment for VEGA-X is under 4 seconds end to end, from photo to feedback, and the operator reads the result from the vibration with both hands on the part.
The deployment above covers snap rings, horseshoe washers and plugs. Other components are assessed with sample images from your floor.
Results can be written to SAP, MES, ERP, WMS or PLC systems, depending on what you use.
If you have a component that keeps causing complaints, request a demo and we can look at your inspection points and sample images together.